When a connected device is initialized as hp, sun, or server using the config init command, the service processor commands become available to help automate server management.
Use the config service-processor command to configure communication with the service processor.
[admin@LantronixLM (port1/2)]# config service-processor
Service processor enabled: false
Change these? (y/n) [n]: y
--- Enter New Values ---
Enable service processor (y/n) [n]: y
Service processor host IP: 10.10.10.2
Service processor IPMI port [623]:
Service processor username: solar2
Service processor password: ********
Confirm Password: ********
Service processor connection type [auto]:
Do you want to commit these changes? (y/n): y
Use the show service-processor commands to view information about the service processor:
show service-processor config — Lists the current configuration of the service processor.
show service-processor events — Displays the service processor log.
show service-processor info — Displays information about the service processor.
show service-processor power — States whether the service processor is powered on.
show service-processor sensor — Displays information from the service processor's sensors to give a low-level view of the server's health.
Use the service-processor execute command to work directly with the service processor.
Command syntax is: service-processor execute [command]
[command] may be any of these:
Channel - Configure Management Controller channels
Chassis - Get chassis status and set power state
Event - Send pre-defined events to Management Controller
Fru - Print built-in FRU and scan SDR for FRU locators
Fwum - Update IPMC using Kontron OEM Firmware Update Manager
i2c - Send an I2C Master Write-Read command and print response
isol - Configure IPMIv1.5 Serial-over-LAN
kontronoem - OEM commands for Kontron devices
lan - Configure LAN channels
mc - Management Controller status and global enables
pef - Configure Platform Event Filtering (PEF)
picmg - Run a PICMG/ATCA).
power - Shortcut to chassis power commands
raw - Send a RAW IPMI request and print response
sdr - Display Sensor Data Repository entries and readings
sel - Display System Event Log (SEL)
sensor - Display detailed sensor information
session - Display session information
sunoem - OEM commands for Sun servers
user - Configure Management Controller users
Use the service-processor power command to control power to the service processor. Command parameters are on, off, and cycle.