In most cases, you will not need to manually set the date and time. NTP is recommended on both the Local Managers and the Control Center for proper synchronization.
To set the date and time manually, use the interactive config date command. Convert your local time to UTC before changing the time on the Local Manager.
Displayed time is based off the timezone setting specified in the logged-in user's account.
[admin@LantronixLM]# show date Displayed time is 07/08/2022 10:36:57 CDT System time is 07/08/2022 15:36:57 UTC
The date and time cannot be set from the Control Center.
To override time and date settings from the Lantronix Control Center, or to specify an NTP server of your own, use the interactive config system ntp command to set the NTP server's IP address and optionally add a secondary server in case the primary server fails.
[admin@LantronixLM]# config system ntp --- Existing Values --- Use NTP: Auto No servers found. Change these? (y/n) [n]: y --- Enter New Values --- Use NTP (y/n/auto) [auto]: y NTP Primary Server IP: 10.10.10.253 NTP Secondary Server IP: Do you want to commit these changes? (y/n): y
The Local Manager will test each IP as they are submitted. If the server does not respond, an error message will be presented:
NTP Primary Server IP: 18.104.22.168 Primary server '22.214.171.124' invalid: server not responding
DNS (configured in config system ip) is required if you would like to use hostnames instead of IP addresses. If DNS is not configured, an error message will be presented:
NTP Primary Server IP: pool.ntp.org Unknown Host (probably malformed IP).
By default, the Local Manager is configured to use DHCP to get an IP address. If DHCP is enabled, and the DHCP server has been configured to return one or multiple NTP server addresses, the Local Manager can automatically configure itself to use those servers. This setting is designated by Use NTP: Auto.
To view NTP settings, use the show system ntp command.
[admin@LantronixLM]# show system ntp Use NTP: Yes NTP Primary Server Hostname or IP: 10.10.10.253
To view additional NTP information, use the show system ntp verbose command.
[admin@LantronixLM]# show system ntp verbose Use NTP: Yes NTP Primary Server Hostname or IP: 10.10.10.253 NTP Secondary Server Hostname or IP: remote refid st t when poll reach delay offset jitter ============================================================================== t1.dfa3.gq1.dfa .INIT. 16 u - 64 0 0.000 0.000 0.000