Interactive command that steps you through the changes needed to update or set the credentials used to communicate with a network device. To set up authentication for the Lantronix Local Manager, use the config system authentication command.
CLI resource: port
Device makes: 3Com, Alcatel, Cisco, Comtech EF Data, Garmin, HP, iDirect, Juniper, ND Satcom, Netscreen, Nortel, Sun, Tasman, TippingPoint, ppp, server
Secondary authentication available on Cisco IOS, Pix, ASA and CatIOS
Power controllers: APC, BayTech, Server Technology
Lantronix system: All
LMS offerings: All
config authentication[admin@LantronixLM (port1/3)]# config authentication
--- Existing Values ---
console user: tasman
console password: ********
enable user:
enable password:
secondary console username:
secondary console password: ********
secondary enable username:
secondary enable password: ********
Change these? (y/n) [n]: y
--- Enter New Values ---
console username: [tasman]:
console password [*********]:*****
confirm password:*****
enable username: []:
enable password []:
secondary console username:
secondary console password: ********
secondary enable username:
secondary enable password: ********
Would you like to test the supplied values? (y/n): y
Testing login will take a few moments...
Login successful; credentials are valid.
Saving credentials.Schedule > Scheduled Tasks - all devices that match the selected filter
Inventory > Local Manager page > port detail > schedule button - specific to this device
--