Manages power from the device's perspective. The power controller must have been previously configured. Multiple outlets are supported to facilitate devices with multiple power supplies.
Following power cycle, the device is checked against a number of measures to assure power cycle was a success. Following power off, console status is checked to make sure device has completely shut down, identified by console electrical signals. Following power cycle or power on, POST (Power On Self Test) takes up to five minutes to time-out if an error has occurred.
Rules can be defined to automate this operation using the powerCycle, powerOff, and powerOn actions.
CLI resource: port, modem
Device makes: All
Modem: All
Power controllers: All
Lantronix Local Managers: All
LMS offerings: All
power <on | off | cycle ["delay"]>The optional delay is in seconds.
[admin@LantronixLM (port1/1)]# power cycle
Powering off outlet(s) [1, 2]
DSR was active.
CTS was active.
CTS is still active.
Powering on outlet(s) [1, 2]
Serial link is active.
Reading post
Image decompressed
Device loaded
Post complete.[admin@LantronixLM (port1/1)]# power on
Powering on outlet(s) [1, 2]
Serial link is active.
Reading post
Device loaded
Post complete.During a terminal pass-through session, you can use the ~p command in the same way.
--