Displays archived power-on self-test (POST) messages. The self-test is only captured if a device reboots or power cycles.
CLI resource: port
Device makes: 3Com, Alcatel, Cisco, HP, iDirect, Juniper, ND Satcom, Netscreen, Nortel, Sun, Tasman, TippingPoint, server
Lantronix Local Managers: All
LMS offerings: All
show post [current | previous | archive #]Specify the POST message to display using the current, previous, or archive # parameter.
[admin@LantronixLM (port1/2)]# show post
WS-X4012 bootrom version 6.1(5), built on 2003.03.19 16:59:08
H/W Revisions: Meteor: 4 Comet: 10 Board: 2
Supervisor MAC addresses: 00:02:16:4d:83:00 through 00:02:16:4d:86:ff (1024 addresses)
Installed memory: 64 MB
Testing LEDs.... done!
The system will autoboot in 5 seconds.
Type control-C to prevent autobooting.
rommon 1 >
The system will now begin autobooting.
Autobooting image: "bootflash:cat4000-k8.7-6-7.bin"
......................................................................................
.......................................................###############################
#
Starting Off-line Diagnostics
Mapping in TempFs
Board type is WS-X4012
DiagBootMode value is "post"
Loading diagnostics...
Power-on-self-test for Module 1: WS-X4012
Status: (. = Pass, F = Fail)
processor: . cpu sdram: . eprom: .
nvram: . flash: . enet console port: .
switch port 0: . switch port 1: . switch port 2: .
switch port 3: . switch port 4: . switch port 5: .
switch port 6: . switch port 7: . switch port 8: .
switch port 9: . switch port 10: . switch port 11: .
switch registers: . switch sram: .
Module 1 Passed
Exiting Off-line Diagnostics
Testing Switch Chip 0 switching memory...passed.Inventory > Local Manager page > port detail > Files > post - specific to this device
1.4 - Locally archived files added.
--