Interactive command to activate or deactivate basic SNMP settings. SNMP may be disabled, or set to one of the following security levels:
noAuthNoPriv security requires that the user connects with the SNMP username, but does no message validation or encryption.
authNoPriv security requires that the user connect with the SNMP username, and makes sure that the message is valid by using the specified auth password.
authPriv security requires that the user connect with the SNMP username, that it has been signed with the Auth password and that it has been encrypted with the Priv password.
For security, Lantronix recommends using the authPriv security level.
CLI resource: system
Lantronix system: All
LMS offerings: All
config system snmp[admin@LantronixLM]# config system snmp
--- Existing Values ---
SNMP is disabled.
Change these? (y/n) [n]: y
--- Enter New Values ---
Security Level (authPriv,authNoPriv,noAuthNoPriv,disabled): [disabled]: authPriv
Port: [161]:
Username: xyzcoAus01
Auth Protocol: [SHA]:
Auth Password: *********
Confirm Auth Password: *********
Priv Protocol: [AES256]:
Priv Password: *********
Confirm Priv Password: *********
Do you want to commit these changes? (y/n): yAuth protocol may be set to SHA (default) or MD5. Priv protocol may be set to AES256 (default), AES192, AES128, or DES.
You will only be prompted for the applicable passwords.
Note: You can set appropriate values for sysContact.0 and sysLocation.0 with the config system properties command.
To disable SNMP, set the security level to disabled.
[admin@LantronixLM]# config system snmp
--- Existing Values ---
Security Level: authPriv
Port: 161
Username: xyzcoaus01
Auth Protocol: SHA
Auth Password: ********
Priv Protocol: AES256
Priv Password: ********
Change these? (y/n) [n]: y
--- Enter New Values ---
Security Level (authPriv,authNoPriv,noAuthNoPriv,disabled): [authPriv]: disabled
Do you want to commit these changes? (y/n): yInventory > group page > Network > SNMP - specific to this inventory group
Inventory > Local Manager page > Network > SNMP - specific to this system
3.4 - This command was introduced to replace config envoy snmp.